Materials for production:Reason: slats of bamboo, pine, linden or plastic sticks from balls. Canvas: tape from 2 cm wide; string, fishing line from 0.5 cm, durable thread; paper, fabric, thick polyethylene, oilcloth fabric; scissors; ruler, weight, knife clerical; pencil or pen; felt-tip pen; glue for moment or PVA. Bridle and handrail: reel of thread or silk thread; rubber ring ( . Discretion) Tail:. thread with a load; bows or tail of paper Now on the market of kites, a host of new and unique models. Professional sports snakes have reached unimaginable sizes, that even with a gale wind these units quietly soar in the sky. But the cost of such structures is very high, so why not make a kite easier out of scrap materials? Today we considerhow to make the kite itself in the form of a hexagon. The manufacturing process The whole structure is built from one main carrier beam and two additional perpendicularly attached. Because of this arrangement of sticks, the stretched canvas resembles a hexagon. All bases are strings or fishing line. 1. We take a wand (in our case plastic). If the base length is less than 40–60 centimeters, then you can glue the two parts together. Cut the line equal to 0.9 length of the rod. (We have a 60-centimeter frame, cut off 54 cm of line). /7/195-izmeryaem.jpg "alt =" measure "title =" measure ">3. We pass the line and fix it on the edge. We made a ball out of ordinary paper, and glued it to the end of the fishing line, after we put it in a tube and dropped it again. When joining two ends of the line with the ends of the tubes, something like an onion is obtained. /7/196-kleim.jpg "alt =" glue "title =" glue "> 4. Do the same with two small chopsticks. We took plastic sticks 30 centimeters long, the length of the line was 27 centimeters. 5.We mark on the main rail the future places of attachment of our auxiliary elements. The distance is measured 0.2 from the entire length of the rod. We got 12 centimeters from each end. (Points H and H1) 6. Fasten additional parts to the base with thread and glue. 7. After the construction has dried up, we stretch the line along the entire perimeter of the hexagon, capturing each vertex. 8. The result was a curved construction, on the one hand, and a second hexagon on the second. 9. Unfold the oilcloth or paper on the table. 10. We lay the flat side of the structure on paper and mark the vertices. Using the obtained points, draw a hexagon. 11. We make allowance in 2-4 centimeters. Cut out the paper. 12. We attach the design and gently fold the sides and glue with adhesive tape. 13. Having pasted over the entire perimeter, we proceed to the manufacture of the bridle and the handrail. 14. On the convex side in the places where beams are attached to each other, we tie a silk thread about 15 centimeters long. We make it two sides. 15. We connect the threads together, we insert a rubber ring (it is possible without it). 16. We tie the main thread to the bridle.
What to feed the chickens
Secrets of cooking delicious cannelloni
And do you like jute splits, as I love him? Amazing works of Vera Pushina
Coaches, coaches, motivators: how not to fall for the bait
What are promotional codes and what are they for?