Installation of a metal-plastic door

Today, in almost all stores and shopping centers, as well as in private homes, people install metal-plastic doors. These doors came to replace the old wooden or metal doors. Metal-plastic doors have a neat appearance, sufficient strength and excellent energy-saving (if you order a double-glazed window with i-glass). And the installation of a metal-plastic door can be carried out independently.
Installing a metal-plastic door
If you still decided to change the appearance of your room and the installation of a metal-plastic door will be done on your own, you must act strictly according to plan. If the door is inside the room - it must be dismantled. Clean out all construction residues so that the base of the walls and the floor is without unnecessary waste. After that, make a measurement of the doorway. If the entrance door - just in the corners knock down the plaster to the base of the walls and floor.Then measure the doorway at the prepared points.
Installing metal doors
Installation of a metal-plastic door
For the installation of a metal-plastic door without difficulty, you must complete the correct order of the door. From the removed sizes it is necessary to take away on 1 sm. From each party and only on such sizes to order a door. This is provided that the doorway is flat. If one side is larger than the other, then the order should be made according to the size of the smaller sides.
Installing metal doors
After placing the order, the door is made about a week. When it is ready and delivered to the right room, the installation of the metal-plastic door begins. First of all, the door must be removed from the hinges so that only one frame remains. Then insert this frame into the doorway and set it strictly according to the level. If necessary, secure it with wedges. After that, fill the entire space between the base of the doorway and the frame with mounting foam.In this state, leave the door frame until the foam is completely dry. It usually takes about 12 hours. After this time the stationery knife cut off the remnants of the dried foam, which protrude out. After that, you can hang the door in place. Be sure to adjust it so that the door never rubbed against the frame, the lock and latch turned around with ease, and the tongue on the handle sat down in its place. If necessary, all mechanisms can be lubricated with a special tool WD-40.
Installing metal doors
Installing metal doors
Installing metal doors
Installing metal doors
Installing metal doors
Installing metal doors
Installing metal doors
Installationplastic door
At the final stage of installation, you must plaster the mounting foam. To do this, it is best to use adhesive for ceramic tiles. When drying, it adheres well to the wall. You can also use regular plaster (cement with sand). Then you need to remove the protective film from the door frame and the door itself. Wipe them from dust and other contaminants. And at this stage the installation of the metal-plastic door is considered complete.


Related News


The test for the erudite: guess the spice on the plant
Buying a used car: what you need to know
How to sew a sheet on an elastic band: a master class with photos
How to make a guest list
The most delicious pizza
Features cooking tandoor